Pit Boss Auger Issues
Posted: Mon Oct 08, 2018 2:21 pm
I own a Pit Boss 820FB. I have used it for over a year without any issues. Lately when firing it up it goes through start cycle then temp goes down and auger wont turn at all. I perform a hard reset and watch the auger, It is supposed to run 4 minutes, it does not do this every time. took auger out and cleaned everything. Started empty, Manual says 3 minutes from when you start in the smoke setting to get pellets to burner pot. It took 4 resets of running 4 minutes each before pellets reached the fire pot. I am guessing auger motor issues or control board. Anyone know how I can check to see if motor is bad or good? Control panel seems ok but not sure if it's internal issues. Thanks in advance.