Looking to get a UDS project going!
Posted: Tue Jan 24, 2017 9:07 am
Hello All,
Looking to get a UDS project going with my neighbor. I live in the Ft. Worth area and had a few questions.
1) Any leads/suggestions on where to find a new virgin drum free of any chemicals?
2) Any suggestions on a place to get it painted, a friend recommended to get a 1500 degree high heat silicone paint job. Not sure if this is necessary but , going with what he had suggested.
3) Did anyone use gasket tape or silicone sealer or both on their drum, if so was it just around the air intakes? Where else would they need to be applied?
I know there are some places on line to buy the kits for baskets, air intakes, handles etc. But I am open to any/all suggestions/input as well.
Thanks
Rob
Looking to get a UDS project going with my neighbor. I live in the Ft. Worth area and had a few questions.
1) Any leads/suggestions on where to find a new virgin drum free of any chemicals?
2) Any suggestions on a place to get it painted, a friend recommended to get a 1500 degree high heat silicone paint job. Not sure if this is necessary but , going with what he had suggested.
3) Did anyone use gasket tape or silicone sealer or both on their drum, if so was it just around the air intakes? Where else would they need to be applied?
I know there are some places on line to buy the kits for baskets, air intakes, handles etc. But I am open to any/all suggestions/input as well.
Thanks
Rob